System Menu
Auto Continue
Sets the printer to ignore an error with paper size or type and continue printing. The printing stops
temporarily when an error is detected, and restarts automatically after about ten seconds using the
settings made on the control panel. However, if the size of paper specified on the control panel
and that of the paper loaded in the paper tray or the paper size specified for the print job do not
match when printing restarts, it may cause a paper jam.
Default: [Off]
• Off
• On
Copies
Sets the machine to print the specified number of sets.
This setting is disabled if the number of pages to print is specified by command or the printer driver.
Default: "1"
• 1 - 999
Sub Paper Size
Sets the printer to print onto paper of another size if the specified paper is not loaded in any tray.
Alternative sizes are preset to A4 and Letter.
Default: [Off]
• Off
• Auto
Def Ppr Size
Specifies the paper size to be used when the paper size is not specified in the print job.
Default: (mainly Europe and Asia) [A4], (mainly North America) [8 1/2 ×
11]
• A4, B5 JIS, A5, B6 JIS, A6, 8 1/2 × 14, 8 1/2 × 11, 5 1/2 × 8 1/2, 7 1/4 × 10 1/2, 8 ×
13, 8 1/2 × 13, 8 1/4 × 13, 16K, 4 1/8 × 9 1/2, 3 7/8 × 7 1/2, C5 Env, C6 Env, DL
Env
Duplex
Sets the printer to print on both sides of paper according to the specified binding method.
Default: [Off]
• Off
• Short Edge Bind
• Long Edge Bind
System Menu
89
To Next Page
Loading...
Need help?
General
Weight and Dimensions
