Rigol MSO1104Z Programming Guide

RIGOL Chapter 2 Command System
2-144 MSO1000Z/DS1000Z Programming Guide
:SYSTem Commands
The :SYSTem commands are used to set the system-related parameters, such as the sound and language.
Command List:
 :SYSTem:AUToscale
 :SYSTem:BEEPer
 :SYSTem:ERRor[:NEXT]?
 :SYSTem:GAM?
 :SYSTem:LANGuage
 :SYSTem:LOCKed
 :SYSTem:PON
 :SYSTem:OPTion:INSTall
 :SYSTem:OPTion:UNINSTall
 :SYSTem:RAM?
 :SYSTem:SETup
:SYSTem:AUToscale
Syntax
:SYSTem:AUToscale <bool>
:SYSTem:AUToscale?
Description
Enable or disable the AUTO key at the front panel, or query the status of the AUTO key.
Parameter
Name
Type
Range
Default
<bool>
Bool
{{1|ON}|{0|OFF}}
1|ON
Explanation
 Users can disable the AUTO key by sending this command or pressing Utility 
Auto Options  Lock. The key can only be enabled by sending this command.
 After the AUTO key is disabled, the Auto Scale operation is invalid. The :AUToscale
command will be invalid.
Return
Format
The query returns 1 or 0.
Example
:SYSTem:AUToscale ON /*Enable the AUTO key at the front panel*/
:SYSTem:AUToscale? /*The query returns 1*/

Rigol MSO1104Z Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Vertical Sensitivity	1 mV/div to 10 V/div
Vertical Resolution	8 bits
Timebase Range	5 ns/div to 50 s/div
Max Input Voltage	300 V (DC + AC peak)
Timebase Accuracy	± 50 ppm
Display	7-inch TFT LCD
Input Impedance	1 MΩ ± 2%
Trigger Modes	Edge, Pulse, Video, Slope, Pattern, Duration, Runt, Window, Nth Edge, Delay, Setup/Hold
Interfaces	USB Host, USB Device, LAN
Power Supply	100-240 VAC, 50/60 Hz, 50 VA max
Memory Depth	12 Mpts (standard), 24 Mpts (optional)
Waveform Capture Rate	50, 000 wfms/s (normal mode)