5
Classic Inclusion (Add to System) - S2
1. For proper inclusion, bring the Range Extender to the final location where it will be used*.
2. Follow the instructions provided in Ring Alarm Mobile Application, enter DSK pin to
enter inclusion mode.
3. Supply power to the Range Extender and then press the button once to begin inclusion
mode using S2 encryption.
4. The device will enter inclusion mode indefinitely and the LED Indicator will blink slowly
(1 flash/2 sec) until it’s included in a system.
5. Upon successful inclusion, the LED Indicator will stop blinking.
Exclusion (Remove from System)
1. Make sure the Range Extender is powered on.
2. Follow the instructions in Ring Alarm Mobile Application to enter exclusion mode.
When prompted by the controller:
3. Press the Button once.
4. Upon successful exclusion, the LED Indicator blink quickly five times and then blink five times
quickly every minute.
* For non Z-Wave Plus networks, please consult the owner’s manual for your primary controller to
determine the best method and location for adding the Range Extender to your Z-Wave network.
Resetting the Extender
If needed, the Range Extender can be reset locally by following these steps. Only do this if your Z-Wave
controller is missing or otherwise unreachable. Beware that resetting your device will disconnect it from
the system:
1. Make sure that your Range Extender is powered on.
2. Press and hold the Button for 10 seconds.
The Range Extender’s memory will be erased to factory settings and the LED Indicator will blink very
quickly six times and then blink once every half second until it is included in a system.
Note: Use this procedure only in the event that the network primary controller is missing or otherwise
inoperable.
Wake-Up Procedure
Ring Alarm Extender is listening device and is always awake as long as it connected to line power or
running on battery.
To Next Page
Loading...
Need help?
General
