Operation
Bluetooth Pairing
To connect your iPod, iPhone, MP3 player, Android phone, or any other Bluetooth-capable
device, follow the steps listed below.
1. Make sure the RCS80-1 unit’s power switch is in the ON position.
2. Turn on the Bluetooth feature on your device and ensure that it is in “discoverable”
mode.
3. Push the Mode button on the unit until you are in Bluetooth mode (LCD screen will
display the word “bLUE”).
4. Once in Bluetooth mode, the unit should automatically pair with your device. If not,
look for “RCS80-1” on your device and select it.
5. If pairing is successful, you will hear a tone.
Please note, the unit will remember the last paired device.
Bluetooth Playback
You can control playback from your device or from the MP3 control panel on the RCS80-1:
1. Play/Pause: press once to play current track, press again to pause.
Vol-/Previous: Long press to decrease volume. Short press for previous track.
Vol+/Next: Long press to increase volume. Short press for next track.
MP3 Volume knob: controls Bluetooth input volume.
2. Playback may also be controlled from your Bluetooth device.
USB/SD
1. Inserting a USB ash drive or an SD card into the corresponding port/slot will set the
RCS80-1 to USB/SD mode and will automatically begin to play music.
2.
Play/Pause: press once to play current track, press again to pause.
Vol-/Previous: Long press to decrease volume. Short press for previous track.
Vol+/Next: Long press to increase volume. Short press for next track.
MP3 Volume knob: controls USB/SD input volume.
Please note, inserting a USB drive or an SD card will override FM radio mode and
Bluetooth mode.
FM Radio
1. Press the Mode key until you enter FM radio mode.
2. Press the Play/Pause button on the unit to initiate auto scan. The unit will automati-
cally search and store stations.
3. Short press the Previous/Next buttons to navigate through preset stations.
To Next Page
Loading...
Need help?
General