Rockwell Automation Publication CC-QS034C-EN-P - March 2015 7
Preface
About This Publication
This quick start provides instructions for implementing a PowerFlex® Compact-class (523, 525, 4, 4M, 40, 40P, 400) AC
drive speed-control application on Modbus by using the Connected Components Workbench™ software and a Micro800®
programmable logic controller (PLC).
To help with the design and installation of your system, application files and other information are provided on the
Connected Components Accelerator Toolkit (CCAT). The CCAT provides bills of materials (BOM), CAD drawings for
panel layout and wiring, control programs, human-machine interface (HMI) screens, and more. With these tools and the
built-in best-practices design, you are free to focus on the design of your machine control and not on design overhead tasks.
The CCAT is available on the Connected Components Accelerator Toolkit DVD, publication CC-QR002, or through
the Rockwell Automation Software Download and Registration System (SDRS) site at
http://www.rockwellautomation.com/rockwellautomation/products-technologies/connected-components/tools/
accelerator-toolkit.page
The beginning of each chapter contains the following information. Read these sections carefully before you begin work in
each chapter:
• Before You Begin - The chapters in this quick start do not have to be completed in the order in which they appear.
However, this section defines the minimum amount of preparation that is required before completing the current
chapter.
• What You Need - This section lists the tools that are required to complete the steps in the current chapter,
including, but not limited to, hardware and software.
• Follow These Steps - This section illustrates the steps in the current chapter and identifies the steps that are required
to complete the examples.
To Next Page
Loading...
Need help?
General
