50
Recording an Electronic Instrument
Here’s how to connect an electronic instrument such as a digital piano or keyboard, and
record your performance.
4
Connect the CD-2u/SD-2u’s LINE IN (L, R) jacks to your electronic
instrument (digital piano, keyboard, etc.).
Use audio cables to connect the CD-2u/SD-2u’s LINE IN (L, R) jacks to the output jacks
of your electronic musical instrument.
fig.connect-piano-e.eps
* Refer to the owner’s manual of your electronic musical instrument for the appropriate type of
plug to use.
5
Turn the [LINE] knob to adjust the input level at the LINE IN (L, R) jacks.
Adjust the loudness of the sound you’re recording. Since you’re not using the mic input,
set the [MIC LEVEL] switch to the “MANUAL” position, and then turn the [MIC] knob all
the way to the left (off).
While producing the sound that you will actually be recording, turn the [LINE] knob to
adjust the input level.
Adjust the level so that the PEAK indicator located above the [LINE] knob lights briefly
at the loudest moments of the performance you’ll be recording.
* When using the [MIC] knob or [LINE] knob, you might hear a slight noise when the recording
level changes; this does not indicate a malfunction.
fig.rec-line-e.eps
If you’re Recording to an SD
Memory Card
If you’re Recording to a
CD-R/RW Disc
1
Turn on the power
(
☞
Page 22, 24)
.
1
Turn on the power
(
☞
Page 22)
.
2
Insert the SD memory card
(
☞
Page 26).
2
Insert the CD
(
☞
Page 29).
3
Set the audio source to “SD”
.
Press the [SD CARD] button so it’s lit.
fig.selectCD-e.eps
3
Set the audio source to “CD.”
Press the [CD] button so it’s lit.
fig.selectSD-e.eps
CD-2u/SD-2u: RCA phono type
Electronic musical instrument: RCA phono type or phone type
Types of plugs that can be connected
To the output jacks of your
electronic musical instrument
RL
LouderQuieter
At this position
PEAK indicator
The level meter will move according
to the level of the audio input.
CD-2u_SD-2u_e.book 50 ページ 2013年1月24日 木曜日 午前11時34分