Roland CX-400 User Manual

46
Key Function Range Default
PRESET This calls up user-set cutting conditions matched to the Preset 1 to 8 –
tool and material in use.
FORCE This sets the force for the blade during cutting. 20 to 350gf 50gf
Perform a cutting test and set the conditions to match (10gf step)
the loaded material and the installed blade.
SPEED This sets the speed for the blade during cutting. 1 to 85 cm/s 50 cm/s
Perform a cutting test and set the conditions to match (1 cm/s step)
the loaded material and the installed blade.
CURSOR These move the material and the carriage. – –
[
] [ ] [ ] [ ] When a menu is displayed, these change the menu
items and setting values.
PAUSE This pauses cutting. The PAUSE LED lights up while – –
operation is paused. Pressing this a second time
cancels the paused state. To quit cutting, hold down
[ENTER] for 0.5 seconds or longer.
This key is also effective when performing material
feed using the [AREA MOVE] menu.
MENU This enters the menu mode. – –
In the menu mode, use the [
] and [ ] keys to move
to the next menu, the [ ] key to move to the setting
screen, and the [ ] key to move to the previous
screen.
ENTER This enables, runs, or stores the item shown on the – –
display.
ORIGIN Holding down this key for 0.5 seconds or longer sets – –
the origin point at the present blade position (the blade
center).
SHEET CUT Holding down this key for 0.5 seconds or longer cuts – –
off the material at the present position of the separating
knife. Press this to sever an already-cut piece of
material from a roll of material. Severing cannot be
performed while cutting is in progress.
TEST CUT Holding down this key for 0.5 seconds or longer – –
performs a cutting test at the present blade position.
For more information, see “4-3 Adjusting the Blade
Force and Cutting Speed.”
MENU + Power on This sets the language for messages on the display. / ENGLISH/ ENGLISH
(LANGUAGE) You can select from among seven languages: PORTUG / ITALIANO/
Japanese, English, Portuguese, Italian, Spanish, ESPAÑOL / FRANÇE/
French, and German. Deutsch
Power on This selects the type of material to use and enables the ROLL/PIECE/ –
(SELECT SHEET) setup state. For more information, see “5-2 Details of F-EDGE/R-EDGE
the Origin-point Location and Cutting Area.”
7-3 List of Functions
Control-key Functions
This describes the functions of the control keys when pressed.

Roland CX-400 Specifications

General

Brand	Roland
Model	CX-400
Category	Plotter
Language	English