Deutsch Français Italiano Español Português NederlandsEnglishEnglish
USING THE UNIT SAFELY
*1 FA-06: KS-18Z/KS-12, FA-08: KS-18Z/KS-12/KS-J8/KS-G8/KS-G8B
IMPORTANT NOTES
WARNING
To completely turn o power to the unit, pull out the plug
from the outlet
Even with the power switch turned o, this
unit is not completely separated from its main
source of power. When the power needs to
be completely turned o, turn o the power
switch on the unit, then pull out the plug from
the outlet. For this reason, the outlet into which you choose
to connect the power cord’s plug should be one that is within
easy reach and readily accessible.
Concerning the Auto O function
The power to this unit will be turned o
automatically after a predetermined amount
of time has passed since it was last used for
playing music, or its buttons or controls were
operated (Auto O function). If you do not
want the power to be turned o automatically, disengage the
Auto O function (p. 9).
Use only the stand that is recommended
This unit should be used only with a stand that
is recommended by Roland.
Do not place in a location that is unstable
When using the unit with a stand recommended
by Roland, the stand must be carefully placed
so it is level and sure to remain stable. If not
using a stand, you still need to make sure
that any location you choose for placing the
unit provides a level surface that will properly
support the unit, and keep it from wobbling.
WARNING
Precautions regarding placement of this unit on a stand
Be sure to follow the instructions in the
“Reference Manual” (PDF) carefully when
placing this unit on a stand.
If it is not set up properly, you risk creating an
unstable situation which could lead to the unit
falling or the stand toppling, and may result in injury.
For details on how to place this unit on a stand, refer to
“Placing This Unit on a Stand” in “Reference Manual” (PDF).
Use only the supplied AC adaptor and the correct voltage
Be sure to use only the AC adaptor supplied
with the unit. Also, make sure the line voltage
at the installation matches the input voltage
specied on the AC adaptor’s body. Other AC
adaptors may use a dierent polarity, or be
designed for a dierent voltage, so their use
could result in damage, malfunction, or electric shock.
Use only the supplied power cord
Use only the attached power cord. Also, the
supplied power cord must not be used with any
other device.
CAUTION
Use only the specied stand(s)
This unit is designed to be used in combination
with specic stands (*1) manufactured by
Roland. If used in combination with other
stands, you risk sustaining injuries as the result
of this product dropping down or toppling
over due to a lack of stability.
CAUTION
Evaluate safety issues before using stands
Even if you observe the cautions given in the
“Reference Manual” (PDF), certain types of
handling may allow this product to fall from
the stand, or cause the stand to overturn.
Please be mindful of any safety issues before
using this product.
Cautions when moving this unit (FA-08)
If you need to move the instrument, take note
of the precautions listed below. At least two
persons are required to safely lift and move the
unit. It should be handled carefully, all the while
keeping it level. Make sure to have a rm grip, to
protect yourself from injury and the instrument
from damage.
• Disconnect the power cord.
• Disconnect all cords coming from external devices.
Keep small items out of the reach of children
To prevent accidental ingestion of the parts
listed below, always keep them out of the reach
of small children.
• Removable Parts
Screws (p. 24)
SD card protector (p. 24)
Handle the ground terminal carefully
If you remove the screw from the ground
terminal, be sure to replace it; don’t leave it lying
around where it could accidently be swallowed
by small children. When refastening the screw,
make that it is rmly fastened, so it won’t come
loose.
Placement
• Do not allow objects to remain on top of the keyboard. This
can be the cause of malfunction, such as keys ceasing to
produce sound.
• Depending on the material and temperature of the surface
on which you place the unit, its rubber feet may discolor or
mar the surface.
You can place a piece of felt or cloth under the rubber feet to
prevent this from happening. If you do so, please make sure
that the unit will not slip or move accidentally.
Maintenance
• For everyday cleaning wipe the unit with a soft, dry cloth
or one that has been slightly dampened with water. To
remove stubborn dirt, use a cloth impregnated with a mild,
non-abrasive detergent. Afterwards, be sure to wipe the unit
thoroughly with a soft, dry cloth.
Repairs and Data
• Before sending the unit away for repairs, be sure to make
a backup of the data stored within it; or you may prefer to
write down the needed information. Although we will do our
utmost to preserve the data stored in your unit when we carry
out repairs, in some cases, such as when the memory section
is physically damaged, restoration of the stored content may
be impossible. Roland assumes no liability concerning the
restoration of any stored content that has been lost.
Additional Precautions
• Any data stored within the unit can be lost as the result of
equipment failure, incorrect operation, etc. To protect yourself
against the irretrievable loss of data, try to make a habit of
creating regular backups of the data you’ve stored in the unit.
• Roland assumes no liability concerning the restoration of any
stored content that has been lost.
• Never strike or apply strong pressure to the display.
• Use only the specied expression pedal (EV-5; sold separately).
By connecting any other expression pedals, you risk causing
malfunction and/or damage to the unit.
• The usable range of D-BEAM controller will become extremely
small when used under strong direct sunlight. Please be
aware of this when using the D-BEAM controller outside.
• The sensitivity of the D-BEAM controller will change
depending on the amount of light in the vicinity of the unit.
If it does not function as you expect, adjust the sensitivity as
appropriate for the brightness of your location.
Using External Memories
• Please observe the following precautions when handling
external memory devices:
• Do not remove the device while reading/writing is in
progress.
• To prevent damage from static electricity, discharge all
static electricity from your person before handling the
device.
• Avoid touching the terminals and protect them from
contact with metallic objects; make sure they stay clean.
• Do not bend, drop, or apply strong force to the device.
• Do not leave the device in locations where it may be
exposed to direct sunlight, or in environments such as a
tightly closed motor vehicle.
• Prevent the device from getting wet.
• Do not disassemble or modify the device.
Intellectual Property Right
• It is forbidden by law to make an audio recording, video
recording, copy or revision of a third party’s copyrighted work
(musical work, video work, broadcast, live performance, or
other work), whether in whole or in part, and distribute, sell,
lease, perform, or broadcast it without the permission of the
copyright owner.
• Do not use this product for purposes that could infringe on a
copyright held by a third party. We assume no responsibility
whatsoever with regard to any infringements of third-party
copyrights arising through your use of this product.
• The copyright of content in this product (the sound waveform
data, style data, accompaniment patterns, phrase data, audio
loops and image data) is reserved by Roland Corporation.
• Purchasers of this product are permitted to utilize said
content (except song data such as Demo Songs) for the
creating, performing, recording and distributing original
musical works.
• Purchasers of this product are NOT permitted to extract
said content in original or modied form, for the purpose of
distributing recorded medium of said content or making them
available on a computer network.
• MPEG Layer-3 audio compression technology is licensed
from Fraunhofer IIS Corporation and THOMSON Multimedia
Corporation.
• The SD logo (
) and SDHC logo ( ) are
trademarks of SD-3C, LLC.
• This product contains eCROS integrated software platform of
eSOL Co.,Ltd. eCROS is a trademark of eSOL Co., Ltd. in Japan.
• Roland, SuperNATURAL, INTEGRA, and D-BEAM are either
registered trademarks or trademarks of Roland Corporation in
the United States and/or other countries.
• Company names and product names appearing in this
document are registered trademarks or trademarks of their
respective owners.
27
To Next Page
Loading...
Need help?
General
Weight and Dimensions
