Roland FC-300 User Manual

30
Patch Mode
You can transmit Control Change messages through operation of the expression
pedals, control pedals, and other controllers.
In keeping with the movement of the expression pedal, Control Change messages
with the controller numbers set for each pedal are transmitted consecutively.
Each pedal is set at the factory as shown below.
All Assign Numbers from 2 on are set to OFF. For more information about the Assign
Numbers, see “Change the Pedal Settings” (p. 42).
You can connect separately available footswitches and expression pedals and use the
external pedals just like the FC-300’s pedals to transmit MIDI messages.
Each pedal is set at the factory as shown below.
All Assign Numbers from 2 on are set to OFF. For more information about the Assign
Numbers, see “Change the Pedal Settings” (p. 42).
Transmitting Control Change Messages
Using the Expression Pedals
Expression Pedal
CC# Range
EXP PEDAL 1 (Assign Number=1)
7 0–127
EXP PEDAL 2 (Assign Number=1) 1 0–127
Using the Control Pedals and Expression Pedal
Switches
Pedal
CC# Range Mode
CTL PEDAL 1
80 0–127 LATCH
CTL PEDAL 2 81 0–127 LATCH
EXP PEDAL SW 1 (Assign Number=1) 82 0–127 LATCH
EXP PEDAL SW 2 (Assign Number=1) 83 0–127 LATCH
For details about the all
parameters and changes the
setting, refer to “Change the
Pedal Settings” (p. 42).
You can use the control pedal
and expression pedal switch to
switch the AMP CONTROL
j
acks – see “Change the Pedal
Settings” (p. 42).
The Control pedal and EXP
pedal are the latch type pedal
that sends an ON or OFF
message each time you depress
it. You can change this to
momentary type operation,
which sends an ON message
when depressed and an OFF
message when released – see
“Mode” (p. 43).
FC-300_e1.book 30 ページ ２００７年４月２４日 火曜日 午前１０時１０分

Roland FC-300 Specifications

Materials

front cloth material	Nylon
inside core material	polyurethane

Weight and Dimensions

dimensions	585 (W) x 210 (D) x 280 (H) mm 23-1/16 (W) x 8-5/16 (D) x 11-1/16 (H) inches
weight	1240 g / 2 lbs 12 oz