117
Sample Edit
Sampling
Truncate
This operation cuts the portions of the sample that are earlier than
the Start Point and later than the Loop End Point.
1.
In the Sample Edit screen, press [F4 (Truncate)].
2.
If you want to replace the current sample with the
truncated sample, press [F4 (Over Write)] to display
the “
✔
” symbol.
3.
Press [F6 (Execute)].
A message will ask you for confirmation.
4.
To execute the Truncate operation, press [F6
(Execute)].
* If you want to cancel without executing, press [F5 (Cancel)].
Create Patch
This operation creates a patch that uses the current sample as the
wave for Tone 1.
If desired, the created patch can also be assigned to the current part.
1.
In the Sample Edit screen, press [F5 (Create Patch)].
The patch name entry screen will appear.
2.
Assign a name to the patch, and save it.
Refer to “Saving a Patch/Rhythm Set” (p. 77).
* If you decide to cancel the Create Patch operation, press [F5 (Cancel)]
to return to the previous screen.
When you execute Create Patch, a sample will be created at the same
time.
When saving the patch, a message will ask you whether you want to
assign the newly created patch to the current part.
3.
If you want to assign the patch, press [F6 (Execute)].
The newly created patch will be assigned to the current part,
and the Patch Edit screen (p. 56) will appear.
4.
If you do not want to assign the patch, press [F5
(Cancel)].
You will return to the Sample Edit screen.
MC-909_Ref_e.book 117 ページ ２００５年３月１日 火曜日 午後３時２９分
To Next Page
Loading...
Need help?
General
