23
Getting Ready
941
Once the connections have been completed, turn on power to your various devices
in the order specified. By turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1
Before you switch on the power, move the volume down all the way by
moving the VOLUME Slider.
Also completely turn down the volume of any connected audio device and other
equipment.
fig.00-09
2
Press the upper portion of the [POWER ON] switch on the back of the
RD-700SX to turn on the power.
The unit is powered up, and the display’s backlighting comes on.
fig.00-10
3
Turn on the power to connected external devices.
4
Adjust the volume of the connected external device.
5
Adjust the RD-700SX’s volume to obtain the proper volume level.
Turning the Power On and Off
Turning On the Power
In the unlikely event the
power is turned off or cut off
while Factory Reset (p. 22) is
in progress, the data may
become corrupted, and it
may require additional time
for the unit to start up the
next time.
To prevent incorrect
functioning of the Pitch Bend/
Modulation Lever (p. 44),
refrain from touching the lever
while the power to the RD-
700SX is turned on.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
power up is required before
the unit will operate normally.
942
RD-700SX_e.book 23 ページ ２００６年３月２３日 木曜日 午後２時５２分
To Next Page
Need help?
General
