35
Performing with the Keyboard
Up to two optional wave expansion boards (SRX series) can be installed into the RD-
700SX.
Use the following procedure when selecting tones stored on an wave expansion
board.
fig.Q1-08p
1
Press ONE TOUCH [PIANO] or [E.PIANO].
This selects a single tone to be played over the entire keyboard.
2
Press EXPANSION [A] or [B] to make its indicator light.
fig.Q1-09g
If you hold down EXPANSION [A] or [B] for several seconds, the name of the
installed wave expansion board appears in the display (p. 17).
3
Press [NUM LOCK] to turn on the button indicator.
4
Press [INC]/[DEC], or press the TONE SELECT buttons to select the
Tone.
When using the TONE SELECT buttons to input Tone numbers, press [ENTER]
afterwards to set the number.
5
Play the keyboard, and you will hear the selected tone.
Selecting Wave Expansion Board Tones
423
1
For instructions on installing
the Expansion Board, refer to
“Installing the Wave
Expansion Board” (p. 15).
For more on the wave
expansion board tone lists,
refer to “Patch List” (for RD-
700) and “Rhythm Set List”
(for RD-700) in the SRX Series
Owner's Manuals. However,
some of the tone names may be
displayed differently on the
RD-700SX. Refer to “Wave
Expansion Board Tone
Name Correspondence
Table” (p. 36).
RD-700SX_e.book 35 ページ ２００６年３月２３日 木曜日 午後２時５２分
To Next Page
Loading...
Need help?
General
