16
Apr.2005
CHECKING THE VERSION
NUMBER
1. Simultaneously hold down the [MIXER], [AMBIENCE], and
[KIT] buttons and turn on the power.
2. Press the [SETUP] button after start up, and the following appears in the
LCD display.
fig.ver1.eps
3. Next, press the [F3] button, and press the [F5] button in addition, the
version number appears in the screen.
fig.ver2.eps
FLASH: Program version number
SRAM: Version number for initial SRAM settings values.
IROM: MAIN CPU version number
IROM(T): TRIG CPU version number
4. Under normal circumstances, confirm only the program version number.
Turn off the power to the unit after confirming the information.
USERS DATA SAVE AND
LOAD
Saving Data
To save data, use the external sequencer as you would when
recording musical data, and perform the following steps
the TD-12 as shown in the following diagram.
1. Connect the TD-12’s MIDI OUT connector with
MIDI cable to the MIDI IN connector of the
external sequencer.
2. Press [SETUP].
[SETUP] lights, and the “SETUP” screen appears.
3. Press [F1 (MIDI)] - [F5 (BULK)].
The “MIDI BULK DUMP” screen appears.
fig.midibulk1.eps
4. Press [+/-], [VALUE], and [CURSOR (up/down)]
to select the content to be sent.
5. Start the recording process of the external
sequencer.
6. Press [F5 (EXECUTE)] to begin sending the
data.
fig.midibulk2.eps
* If you want to stop sending, press [F1 (STOP)].
7. When finished, the following screen appears.
fig.midibulk3.eps
Bulk Dump is one kind of System Exclusive message. Be
sure to use an external MIDI sequencer that is capable of
recording System Exclusive messages. In addition,
confirm that the sequencer is not set to “Do not receive
System Exclusive messages.”
Loading Data to the TD-12
At this time, all the TD-12’s current data is overwritten.
Make sure you have made the needed backup.
1. Connect the TD-12’s MIDI IN connector with a
MIDI cable to the MIDI OUT connector of the
external sequencer.
2. Press “PLAY” on the external sequencer to
transmit the data to the TD-12.
Received data is written into the TD-12.
To Next Page
Loading...
Need help?
General