Roland TD-7 User Manual

2. Phrase Sequencer
The 'l'D-‘.-’ is equipped witlt___;t__seqne_t1eer_tlt:;tt allows ygu to tfrertte q_r__iginztl___rl1ytltnjsanti l}z_1ss_pa_tt:ern_s.
The SBQUGHCBF is the unit that ret'ort"ls purl fer lie}.-'l)n;1rtl"l 'p'er'for1'h:tn'te' tlatzt tint! plli-tiysliitiléztlelt. The
Set]uent't.=r rztn ;-tlsri he s_\_='neltrt;tt‘ti?'.e(l to zmnt her MlDl c.levit.'.e. '
O The TD-7 contains 24 different Preset Patterns and can store up to 24 User
Patterns. Original Sequence Patterns are stored in User Patterns; the
contents of the Preset Patterns cannot be changed.
I Pattern Numbers 1 - 24 are User Patterns, and Pattern Numbers 25 - 48 are
Preset Patterns.
The 'TD—T's Tour Seetiotts can he pluyetl. The lour settitms are: the |fiSti't.tI’fl8M SBCUOFI,
Performance Section 1, Performance Section 2 and Performance Section 3.
Eztelt of the it Sections is assigned its own .\-'ll[)l cltrtnnel. Therefore. wltat can he recortled/'played hztck
must he d;tt;t that uses one of these same +i channels. and it will he recorded./plztyed back as helonging
to the Ser.'tion that is ztssignecl the same clutnnel as the that nnel the performance data tnwelecl on. This
is true whetherit is perlonnztntie data generated by ltittirtg the pads. orthat :tn"ivingoverMfDl'lN. However.
The MIDI channel is not recorrletl in the Pltntse Sequencer. Sequence data is distinguished by the
settion rt:-tine. '
l
’ 77777 W’ jg f *7" W Pei" ~ W is —*e ———— ————— —— —— — —— — — — —¥—— *2‘ l
»;:. r ,s___.._-__.
Ql%_ s§f_|Eé';‘;5 ‘F » CH':mEl_.;l mg-égt_:_:;NT INSTURUMENTSJ
x 1
1 I
, , I . . H . 777 e .
=
‘ uses : , I‘ A ENSTURUMENT
PHRASE I ‘F ) 1 _ ~ J‘
stzouaucat=|"'i 2'4 Ti
1 ‘oi--*'+- eenaontrititcéi 1
y Q 25 p ghMDt_
l * = ,¢‘.~3L'.é.t_~lE..E.l.~.» sacnonz A ‘“ST“““'“E'“
PRESETE P ' *""""*""* * "WT "
‘ ‘ ’ 1"r""t."rr;r*- PEHFORMATNTCGT ‘
y I I Q AINST R ENT
_. t , ..e*-eta-» ,.
fit?
O Only Note On and Control Change (of the Hi-hat Control Pedal), messages
are recorded in the Phrase Sequencer. No other messages are recorded.
That is, onlythe data set with the "SYSTEM" parameters (er P. 1 21 ) is recorded.
I Though the MIDI channel is not recorded in the Phrase Sequencer, sequence
data can be distinguished by the section name. MIDI messages are output
to external devices on the MIDI channel set in the Instrument or Performance
section. For example, if channel 2 is set in Performance section 1, sequence
data of Performance section 1 will be tranmitted on channel 2.
J I
l
l
=l=
[_-:,\
=i=
The amount of data that
can be recorded in the
TD-7's sequencer is
limited. That is, when you
have created Sequence
Patterns with a lot of data,
you may not have room
tor 24 different patterns.
Check the amount of
memory remaining using
Available Memory (+ P.
105)
For a detailed expla-
nation about MIDI chart»
nel settings. refer to page
115. 116.-P
The Phrase Sequencer
does not record Note Oh‘
messages (=1? P. 111).
When the seeuencer is
playing back data, a Note
O11 message is output
immediately after a Note
On. T
95 Chapter 5 The Phrase Sequencer

Roland TD-7 Specifications

General

Brand	Roland
Model	TD-7
Category	Recording Equipment
Language	English