4
Turn on the power of the connected amp or audio system.
5
Raise the [GROUP FADERS] sliders to the maximum position, and adjust [MASTER] ([PHONES])
to the position shown in the diagram.
fig.00-014a
6
While striking [PREVIEW] with your finger, adjust the volume of the connected amp or audio sys-
tem. If you are using headphones, gradually raise [PHONES] to adjust the volume.
The TD-10 will produce sound. The volume will depend on the force with which you struck [PRE-
VIEW].
You can use [TRIG SELECT] to select and audition the instrument for each pad.
■ To turn the power off ...
1
Make sure that the TD-10 volume controls and the connected external devices are turned to the
minimum position.
2
Turn off the power of the external devices.
3
Turn off the power of the TD-10.
If there is no sound when you strike [PREVIEW] ...
Check the following points.
· If you are using headphones, are they connected to the PHONES jack?
· If you are using an external amp, is it connected to the MASTER jacks? Are the
audio cables connected correctly to the input jacks of the external amp, etc.?
· Could there be a problem with the cables connected to the external amp?
· Are the input select settings of the external amp correct?
· Are the [GROUP FADERS] sliders lowered?
· Could the [PHONES] volume be too low?
· Could the [MASTER] volume be too low?
To Next Page
Loading...
Need help?
General