To Next Page

To Previous Page

Appendices

Setup Screens

Audio Channels 1–4 (Audio Channel 1–4 [SETUP] Buttons)

Setting item Value Explanation

GAIN 0–64 dB This adjusts the input sensitivity.

LEVEL 0–127 This adjusts the volume level of audio channels 1 through 4.

AUX SEND 0–100–127 This adjusts the send level of audio to the AUX bus.

REV SEND 0–100–127 This adjusts the send level of audio to Reverb.

PAN LEFT–CENTER–RIGHT This adjusts the sound position (pan).

EQ HI -15–15 dB This boosts or attenuates the high band.

FREQ 700 Hz–8.00 KHz–11.0 KHz This adjusts the center frequency when changing the sound quality in the high band.

EQ MID -15–15 dB This boosts or attenuates the middle band.

FREQ 20.0 Hz–2.50 KHz–10.0 KHz This adjusts the center frequency when changing the sound quality in the middle band.

Q 0.5–16.0 This adjusts the width of the frequency band when boosting or attenuating the middle band.

EQ LO -15–15 dB This boosts or attenuates the low band.

FREQ 55 Hz–110 Hz–800 Hz This adjusts the center frequency when changing the sound quality in the low band.

GATE ON, OFF This sets gate on or o.

THRESHOLD -50–-48–0 dB This sets the level used as the threshold for removing audio. Audio below the level set here is removed.

RELEASE 30–500–5000 ms This adjusts the length of time until the gate eect ends after audio falls below the threshold.

COMP ON, OFF This sets the compressor on or o.

THRESHOLD -50–-16–0 dB

This sets the level used as the threshold when compressing audio. Compression is applied to audio that

exceeds the level set here.

RATIO

1.0:1, 1.2:1, 1.5:1, 2.0:1, 2.8:1, 4.0:1, 8.0:1, 16:1, INF:1

This species the degree of compression applied to the audio. The state in which no compression is

applied is dened as “1.”

ATTACK 0.2–50–100 ms This sets the time until compression starts when audio exceeding the threshold is input.

RELEASE 30–500–5000 ms This adjusts the length of time until compression ends after audio falls below the threshold.

HPF ON, OFF This sets the high-pass lter on or o.

DELAY 0.0–500.0 ms This adjusts the delay time for audio.

AUX DELAY 0.0–500.0 ms This adjusts the delay time for audio sent to the AUX bus.

SOLO ON (blue), OFF

This sets the Solo feature on or o. Only the input audio for the channel which has solo “ON” can be

monitored via headphones.

MUTE ON (red), OFF This sets the Mute feature on or o. Input audio for which this is set to “ON” is silenced.

Audio Channels 5/6 and 7/8 (Audio Channel 5/6 and 7/8 [SETUP] Buttons)

Setting item Value Explanation

LEVEL 0–127 This adjusts the volume level of audio channels 5/6 and 7/8.