Roland XV-5080. - Setting a Patchs Pitch in Octave Steps (Octave Shift); Selecting How a Patch will Play (Polyphonic;Monophonic)

23
Chapter 1 Selecting and Playing a Sound
Chap.1
212), modify the third byte to the appropriate value when
transmitting the above exclusive message.
Setting a Patch’s Pitch in
Octave Steps (Octave Shift)
In Patch mode, you can easily change the pitch of an entire
Patch.
Each time you press [ ]/[ ], the pitch will change in one-
octave steps. You can adjust a Patch’s pitch by as much as +/
- 3 octaves.
fig.01-004.e
Selecting How a Patch Will
Play (Polyphonic/
Monophonic)
You can set whether a Patch will play multiple notes at the
same time (Polyphonic) — for example, when you play a
chord or legato line — or whether only the last-played note
will be heard (Monophonic).
1. Select the Patch you wish to use. (p. 19)
2. Press [F1 (Common)].
3. Press [F2 (Control)].
fig.01-005.e
4. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
“Mono/Poly.”
5. Turn the VALUE dial, or press [INC]/[DEC] to select the
desired value.
6. After making the setting, press [EXIT].