69
Chapter 2 Using the XV-5080 Effects
Chap.2
Output
Level (Output Level)
Adjust the output level.
46:REVERSE DELAY
Reverse Delay is a delay effect that adds the reverse of the
input sound as the delay sound.
fig.2-56
Delay
1 (Delay Time 1)
Adjust the delay time from the original sound until the delay
1 sound is heard.
2 (Delay Time 2)
Adjust the delay time from the original sound until the delay
2 sound is heard.
3 (Delay Time 3)
Adjust the delay time from the original sound until the delay
3 sound is heard.
4 (Delay Time 4)
Adjust the delay time from the original sound until the delay
4 sound is heard.
Feedback
Feedback 1:4 #
Adjust the proportion (%) of the delay 1 and 4 sound that is
fed back into the effect. Positive (+) settings will return the
signal to the input with the original phase, while negative (-)
settings produce an inverted phase.
HF Damp
HF Damp 1:4
Adjust the frequency above which delayed sound (Delay 1,
4) fed back to the delay input will be cut.
If you do not want to cut the high frequencies of the
feedback, set this parameter to BYPASS.
Level 1:2:3
Adjust the output level of delay 1, 2 and 3.
Pan 1:2:3 (Output Pan 1:2:3)
Adjust the pan of delay sound (Delay 1, 2, 3). A setting of L64
is far left, 0 is center, and 63R is far right.
Threshold
Thresh (Threshold Level)
Specify the volume level at which the reverse delay will
begin to apply.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance (Effect Balance) #
Sets the volume balance between the source sound and the
effect sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the effect sound
will be output.
Output
Level (Output Level)
Adjust the output level.
Feedback
L in
R in
Rev. Delay
L out
R out
2-Band
EQ
2-Band
EQ
1
2
D1
Delay
3
D3
D2
D4
To Next Page
Loading...
Need help?
General
