RPBS-1 PORTABLE SCALE 2.0 14
Hidden Parameters
The RPBS-1 has hidden parameters for weight calculations and
measurements that are generally set and not routinely adjusted. These
parameters have a different access format to protect them from being
accidentally altered.
The following are included in this section:
Hidden Parameters
Accessing Hidden Parameters
Hidden Parameters Description
The following are descriptions of RPBS-1 hidden parameters:
A. Weight unit of measure. Displays the weight units in kilograms (Kg)
and or pounds (Lb). Select from 0 for kg, 1 for lbs. Default value is 0.
B. Scale calibration number. After calibration, the RPBS-1 provides a
calibration number that overwrites the default value. Note the number
and use it instead of calibration after a cold start. Default value is 6500.
C. Number of individuals per weighing (1-10). To weigh more than one
bird at a time, change this value and the RPBS-1 calculates the
individual weight of each bird. Default value is 1.
D. Scale sensitivity (expressed in percent). The RPBS-1 sensitivity
value is a tolerance percent above and below A/D count average to
perform the weighing. When set at a low percentage setting, shifting
and strong movement prevents accurate weighing. The RPBS-1
performs the weighing only after stabilization and halt in bird movement
more than the set percent above and below. A low percent setting
results in higher weight accuracy and slower operation. Higher values
indicate less accuracy and quicker weighing. Default value is 2.
E. Uniformity percentage range. Default value is 10%. Alter the range (in
percent) for calculating uniformity according to this formula:
number of bird weights within ±10% (to 30%) of average
To Next Page
Loading...
General