Royal Enfield Himalayan
116
WASHING PROCEDURE
PRECAUTIONS
Remove ignition key and seal the ignition key barrel
slot using adhesive tape.
Please remove tool kit and other relevant documents if
any underneath the pillion seat before proceeding for
washing of the motorcycle.
Cover the silencer tail pipe, horn and control switches
with suitable plastic bags and tie if firmly to prevent
water entry.
Wash the motorcycle only when the engine is in cold
condition.
Do not remove side panel while washing to avoid
water entry.
Brush engine area with a recommend non corrosive
solvent to remove dirt or grease.
Use low pressure water jet to clean.
Never spray water with great force on head lamp,
speedometer, flasher lights, front and rear wheel hubs,
electrical connections and wires, control cables, spark
plug, battery, ABS ECU, EMS ECU, side mirrors, steer-
ing stem etc.
Do not use high pressure washers or steam jet cleaners
near the seal of headstock bearing or steering stem
bearing, seal of wheel bearing, brake calipers, air
intakes & exhaust outlets.
Do not apply any corrosive solvent on painted surfaces
or rubber parts.
Use lukewarm water and mild detergent on the
painted components to remove dirt, etc.
Clean motorcycle thoroughly with plain water to
remove the detergent.
Never spray water towards bottom side of instrument
cluster directly to avoid water entry through breather
holes.
If possible, use compressed air and blow off water par-
ticles from the obscure areas of the motorcycle,
electrical connections etc.
To Next Page
Loading...
Need help?
General
