R5 Series
be aware of the high-voltage device.
Chapter 2 Preparation
2.1 Safety Instructions
· There is possibility of dying due to electrical shock and high voltage.
· Do not touch the operating component of the inverter, it might result in burning or death.
· To prevent risk of electric shock during installation and maintenance, please make sure that
all AC and DC terminals are plugged out.
· Do not touch the surface of the inverter while the housing is wet, otherwise, this may cause
electrical shock.
· Do not stay close to the inverter while there are severe weather conditions including storm,
lighting, etc.
· Before opening the housing, the SAJ inverter must be disconnected from the grid and PV
generator; you must wait for at least five minutes to let the energy storage capacitors
completely discharged after disconnecting from power source.
· The installation, service, recycling and disposal of the inverters must be performed by
qualified personnel only in compliance with national and local standards and regulations.
· Any unauthorized actions including modification of product functionality of any form may
cause lethal hazard to the operator, third parties, the units or their property. SAJ is not
responsible for the loss and these warranty claims.
· The SAJ inverter must only be operated with PV generator. Do not connect any other
source of energy to the SAJ inverter.
· Be sure that the PV generator and inverter are well grounded in order to protect properties
and persons.
· The solar inverter will become hot during operation. Please do not touch the heat sink or
peripheral surface during or shortly after operation.
To Next Page
Loading...
Need help?
General
