7 Day Mode
The RT500 also offers a 7 day programming mode, which allows you to
programme five different sets of time and set point temperatures for each
day of the week to give a total of 35 separate programme settings.
To review or change a programme, press the SET key when the RT500 is in
Normal mode. This will change the unit status to Programme Setting
mode.
The LCD display will display
programme number 1 and SET
PROG, with all other indicators
cleared. The weekdays will be
flashing to indicate they are the
selected item and are ready to be
adjusted.
Press the UP or DOWN key to
change the display to indicate the
single day you want to programme:
Pressing the SET key at any time when in programming mode will return
the RT500 into Normal mode. Press the SELECT key to confirm the Day
selection. Once this is set, the ‘Hour’ will flash to indicate that it is the
selected item and is the next item to be adjusted:
Press the UP or DOWN key to adjust the hour setting to the desired value,
and confirm your selection by pressing the SELECT key.
RT500 INSTRUCTION MANUAL
13
To Next Page
Loading...
Need help?
General
