Disassembly and Reassembly
63
No Parts Procedure Remark
1
ELECTRICAL
EQUIPMENT PARTS
1) Remove 4 screws from the Cabinet.
(Use + Screw Driver)
2) Remove the 4 screws and then separate the
Cover Control Box part.
(Use + Screw Driver)
3) Remove the Power, Pump, 3way valve, Flow
sensor, Booster Heater, Back-up Heater, Sensor
connector of Assy PCB.
3-2-3 TDM PLUS Tank Integrated Hydro Unit
■
AE***TNWTEH
Be sure that the power switch is in the OFF and the power source cord shall be unplugged prior to disassembly and reassembly works.
To Next Page
Loading...
Need help?
General
