108
Shooting Functions > Flash
You can also drag the slider or touch / to adjust the intensity.
Adjusting the flash intensity may not be eective when:
-
The subject is too close to the camera.
-
You set a high ISO sensitivity.
-
The exposure value is too big or too small.
-
It is too bright or too dark.
In some shooting modes, you cannot use this function.
If you attach an intensity-adjustable external ash to the camera, the intensity
settings of the ash will be applied.
If the subject is too close when you use the ash, some light may be blocked,
resulting in a dark photo. Ensure that the subject is within the recommended
range, which varies by lens.
When a lens hood is attached, the light from the ash can be blocked by the
hood. Remove the hood to use the ash.
Flash settings
Set the ash mode, exposure value, ash brightness, or multi ash when
you attach an external ash to the camera. You can also set wireless sync to
control the external ash. The ash settings are supported only when you
attach a compatible, optional external ash (SEF-580A).
Setting external ash
To set external ash,
In Shooting mode, press [m]
ĺ
b
ĺ
External Flash
Settings
ĺ
an option.