31
Before connecting cables
The color and shape of parts may differ from what is shown. Specifications are subject to change without notice to improve quality.
Unfasten the screws, then remove the cover.
2
Silicone bar
Remove the appropriate silicone bar for the
thickness of the cable to connect.
Different hole sizes and corresponding cable
thickness for each:
* JACK
7 Ø hole x 2: Insert the 7 Ø cable
5.5 Ø hole x 6 : Insert the 5.5 Ø cable
3 Ø hole x 4 : Insert the 3 Ø cable
* POWER INLET
7 Ø hole x 1: Insert the 7 Ø cable
3
Insert the appropriate cable into the hole from
which the silicone bar was removed.
4
The cable should be connected as shown.
5
Close the cover, then fasten the screws.
After all the cables are connected, make sure to
close the cover and fasten the screws to ensure it is
water tight.
Recommended torque : 10 - 12 kgf.cm
To Next Page
Loading...
Need help?
General
