S&C 2030 User Manual

2 S&C Instruction Sheet 716-500
Qualified Persons
WARNING
The equipment covered by this publication must be installed, operated, and maintained
by qualified persons who are knowledgeable in the installation, operation, and mainte-
nance of substation and overhead electric power distribution equipment along with the
associated hazards. A qualified person is one who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from non-live
parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances cor-
responding to the voltages to which the qualified person will be exposed
• The proper use of the special precautionary techniques, personal protective equipment,
insulating and shielding materials, and insulated tools for working on or near exposed
energized parts of electrical equipment
These instructions are intended only for such qualified persons. They are not intended to
be a substitute for adequate training and experience in safety procedures for this type of
equipment.
Read this
Instruction Sheet
NOTICE
“Thoroughly and carefully read this instruction sheet and all materials included in the
product’s S&C Instruction Handbook before installing or operating your S&C Series 2000
Circuit-Switcher, Model 2030. Familiarize yourself with the Safety Information and Safety
Precautions on pages 4 through 8.
Retain this
Instruction Sheet
This instruction sheet is a permanent part of your S&C Series 2000 Circuit-Switcher,
Model 2030. These instructions should be stored in the Series 2000 Switch Operator using
the instruction manual holder. The latest version is available online in PDF format at
sandc.com/Support/Product-Literature.asp.
Proper Application
WARNING
The equipment in this publication must be selected for a specific application. The
application must be within the ratings furnished for the equipment. The ratings for this
circuit-switcher are listed on the nameplate on the front of the switch operator. Additional
application information can be found in Specification Bulletin 716-31.
Usual Operating
Conditions
Series 2000 Circuit-Switchers will perform as intended at temperatures within the range
of –40°C to +40°C (–35°C to +40°C for 161-kV and 230-kV models), at altitudes of up to 5000
feet, and at wind loadings of up to 90 miles (145 km) per hour. Further, Series 2000 Circuit-
Switchers, when installed with the recommended S&C anchor bolts and with exible-conductor
connections at all six terminal pads, are capable of withstanding seismic loading of 0.2g
ground acceleration in any direction and performing as intended during such loading and
afterward. For applications at temperatures not within the specied range, at higher altitudes,
at higher wind loadings, or where higher seismic-withstand capabilities are required, refer
to the nearest S&C Sales Ofce.
Introduction

S&C 2030 Specifications

General

Brand	S&C
Model	2030
Category	Switch
Language	English