To Next Page

To Previous Page

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote

control codes prevents interference from other remote controls when several projectors or video equipment

next to each other are operated at the same time. Change the remote control code for the projector first before

changing that for the remote control. See “Remote control” in the Setting Menu on page 52.

Remote Control Code

Part Names and Functions

Check the Reset Switch to "Use position" in the

compartment lid on the back of the remote control.

During holding down the MENU button, press the

IMAGE ADJ. button corresponding times to the

number of the remote control code for the projector.

Remote Control Code

Number of Times

Pressing IMAGE ADJ.

button

Code 1 1

Code 2

Code 3

Code 4 4

Code 5 5

Code 6 6

Code 7 7

Code 8 8

Use position

Reset position

Reset switch

IMAGE ADJ.

button

MENU button

Sanyo PLC-XF70 User Manual

Other manuals for Sanyo PLC-XF70