www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
22
|
GB
Maintenance
Please adhere to the maintenance schedule.
Daily before beginning work
Check fuel tank and fuel lines for tightness.
oil, position of the auger and functioning of the oper-
ating elements.
After 20 operating hours
After 100 operating hours
Clean fuel tank and replace spark plug
After 300 operating hours
Important notice in the event of repairs:
When sending earth augers to be repaired, please
to the service station free from oil and petrol.
Warning! No smoking and no open re.
Risk of explosion.
Air lter, g. 4-5
malfunctions.
• -
• Replace the damaged element.
•
clean, damp cloth.
•
check it for damage, replace if required.
•
Warning!
Do not use petrol or cleanser.
Risk of explosion.
•
when it is damaged. This can cause motor damage.
In this case: The manufacturer is not liable for dam-
the user.
Spark plug g. 6-7
-
tion. Wait for the motor to cool down.
Starting the motor: (g. 3)
•
position.
•
position.
•
•
•
CAUTION!: Do not pull out the starter cable more
-
• position.
• Pull the starter cord 2-3 times again until the motor
•
when the throttle lever is used.
Stop the engine
to the ‘Start’ position.
Before starting the motor, check the following:
•
• Condition of the fuel lines
•
•
Operating
• Set the auger down and actuate the throttle con-
• -
•
-
When leaving the auger, the motor must always
be turned o.
9. Cleaning and maintenance
Cleaning
• -
•
and some soft soap. Do not use cleaning agents
the equipment. Ensure that no water can seep into
the device.