www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
33
both perpendicular and 45° angle settings.
• Important!
The work to change and align the saw blade (6)
10.6 Adjusting the laser (g. 19-20)
If the laser (32) ceases to indicate the correct cutting
screws (32b) and remove the front cover (32a). Loos-
-
the saw blade (6).
After adjusting and tightening the laser, mount the
The machine must be connected to the mains in order
to adjust the laser.
Attention!
Never press the ON/OFF switch (2) when adjusting
the laser. Danger of injury!
10.7 Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the follow-
ing parts are therefore also required for use as con-
sumables.
Wear parts*: carbon brushes, saw blade, table insert
(art. no. 5901215010), saw dust bag
11. Transport
•
• Press the machine head (4) downwards and secure
with the locking bolt (23).
• Fix the saw’s drag function with the locking screw
for drag guide (20) in rear position.
•
• When reassembling the equipment proceed as de-
scribed under section 8 and 9.
12. Storage
frost-proof place that is inaccessible to children. The
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical tool.
10.4 Brush inspection
hours with a new machine, or when new brushes have
If the carbon is worn to a length of 6 mm, or if the
spring or contact wire are burned or damaged, it is
found to be usable following removal, it is possible to
reinstall them.
When servicing the carbon brushes, open the two
latches counterclockwise (as shown in Figure 21).
Then remove the carbon brushes.
Replace the carbon brushes in the reverse order.
10.5 Changing the saw blade (g. 1/2/14-17)
Remove the power plug!
Important!
Wear safety gloves when changing the saw blade.
Risk of injury!
• Swing the machine head (4) upwards and lock with
the locking bolt (23).
• Loosen the retaining screw (5a) of the cover using a
WARNING!
• Fold the saw blade guard (5) upwards until the saw
•
screw (28).
•
• -
The saw shaft lock (30) engages after no more than
one rotation.
•
screw (28) in the clockwise direction.
•
•
out downwards.
•
• Fit and fasten the new saw blade (6) in reverse or-
der.
• Fold the saw blade guard (5) downwards until the
saw blade guard (5) engages in the locking screw
(5a).
• Re-tighten the locking screw (5a).
• Important!
The cutting angle of the teeth, in other words the
direction of rotation of the saw blade (6) must coin-
cide with the direction of the arrow on the housing.
• -
• Important!
To Next Page
Loading...
Need help?
General
