www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
34
|
GB
AC motor:
The mains voltage must be 220 - 240 V
~
.
• Extension cables up to 25 m long must have a
cross-section of 1.5 mm
2
.
Please provide the following information in the event
•
•
14. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
The equipment and its accessories are made
and plastic. Defective components must be disposed
council.
Old devices must not be disposed of with house-
hold waste!
be disposed of together with domestic waste in
compliance with the Directive (2012/19/EU)
pertaining to waste electrical and electronic
equipment (WEEE). This product must be disposed of
at a designated collection point. This can occur, for
-
ic equipment. Improper handling of waste equipment
-
substances that are often contained in electrical and
of natural resources. You can obtain information on
-
-
13. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer‘s mains connection as well as the ex-
tension cable used must also comply with these
regulations.
• The product meets the requirements of EN 61000-
3-11 and is subject to special connection conditions.
-
lectable connection point is not allowed.
•
-
•
mains of at least 100 A per phase must be given.
•
product meets one of the two requirements, a) or b),
-
Important information
In the event of an overloading the motor will switch
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
not hang on the power network during the inspection.
-
-
tion cables of the same designation.
If the power cord of this device is damaged, it must be
from the manufacturer or its service department.
To Next Page
Loading...
Need help?
General
