Restore Factory Settings
If you lose or forget your Programming Code, you can restore the factory settings, which will restore the default
Programming code.
1. Disconnect the battery.
2. Press and release the Schlage button.
3. The following steps must occur within 10 seconds:
a. Reconnect the battery. The Schlage button will light green for one second.
b. Then, press and hold the Schlage button until it lights green and the lock beeps.
4. Try entering one of the default User Codes. If it does not unlock the lock, start over at step 2.
Once you’ve done this, you can change the programming code to a personalized number. See Changing the
Programming Code* on page 11.
WARNING
Locate the default Programming and User Codes on the front of this guide or the back of the Keypad Assembly
before beginning! Default Programming and User Codes will be restored. All existing User Codes and current
Programming Code will be erased.
CUSTOMER SERVICE CANNOT RETRIEVE LOST DEFAULT CODES! DO NOT RESTORE FACTORY SETTINGS
UNLESS YOU CAN LOCATE THE DEFAULT CODES.
Download
To Next Page
Loading...
