18
4.2 GENERAL FUNCTIONS
Power ON
Press for 2 seconds
3 BLUE ashes with ascending tone
Power OFF
In Standby, press for 2 seconds
3 RED ashes with descending tone
Volume
Tap
a
or
a
to adjust and set volume of current
audio source
Mute / Unmute Tap
a
and
a
simultaneously
Enable / Disable
VOX (For Intercom
calls only)
In standby, press
a
and
a
simultaneously for
2 seconds
ENABLED: Blue ash for 2 seconds
DISABLED: Red ash for 2 seconds
4.3 STATUS LIGHTS
None SRC-System™ is OFF
1 BLUE ash every 3 seconds
Standby mode
No active audio sources
2 BLUE ashes every
3 seconds
Active mode – Call in progress / music
or other audio source is ON
1 RED ash every 3 seconds Standby mode – Battery is low
2 RED ashes every 3 seconds Active mode – Battery is low
Solid RED Charging
4.4 AUDIO SOURCES AND PRIORITIES
If two connected audio sources try to play audio simultaneously, your
SRC-System™ automatically determines which audio source to play
through the speakers based on the priority of the connected devices.
Higher Priority
1. Mobile Phone audio or GPS instructions*
2. Intercom / Click-to- Link
3. A2DP (Stereo Bluetooth) audio
* GPS instructions from Smartphone GPS Apps are
prioritized like A2DP audio
Lower Priority
For example:
• Incoming mobile phone calls interrupt ongoing intercom calls
• Incoming intercom calls will interrupt ongoing A2DP music
• Intercom and Click-to-Link calls have the same priority. So
Click-to-Link calls will not interrupt any Intercom call in progress,
and vice-versa.
A2DP audio priority can be congured higher than Intercom audio
priority – see section 3.
4.5 VOICE CONNECT VOX SETTINGS
Your SRC-System™ oers VOX technology for safe and hands-free
operation of some key functions.
The VOX can be customized to adjust its sensitivity level. VOX
activation for Intercom calls can also be disabled completely.
You can choose between ‘High’, ‘Medium’ (default) and ‘Low’ VOX
sensitivity.
If you experience diculties starting a conversation using VOX,
change setting to ‘High’.
If VOX keeps starting calls involuntarily, change setting to ‘Low’.
To Next Page
Loading...
Need help?
General
