74
LC-19LE510
LC-22LE510
LC-24LE510
1. Please copy the files to USB (root).
• mb60_en.bin
• mboot.bin
• usb_auto_update.txt
2. Turn power to OFF by mechanical switch(rocker switch) or removing AC
plug. And plug the USB to TV
3. Keep pressing OK key from remote controller and then turn the TV power
to ON(by mechanical switch or by inserting the AC plug) and keep OK key
pressed until the stanby led blinks rapidly(rapid blinking is faster than
normal blinking)
4. When the led is started to blink rapidly, you can release the OK key.Please
wait approximately for 1-2 minutes.
5. When the blinks of led is stopped, TV opens autamatically with the new
SW.
Analog - Digital SW update via USB
24.6. USB Operations
USB operations option cannot be used directly. It can be used for updating panel tool, hw configuration
etc.
In MB60 project there is only one software. From following steps software update procedure can be seen:
MB60_en.bin, mboot.bin and usb_auto_update_T4.txt documents should copy directly
inside of a flash memory(not in a folder).
Put flash memory to the TV when TV is powered off.
Power on the Tv .
While the Tv is switch on press OK button consecutively.
The Tv’s Led will blink faster then stand_by mode.
If First Time Installation screen comes, it means software update procedure is successful.
To reach the latest sw file please use;
https://www.vestelservice.com/100359/New_Projects/Sharp/Sharp_2011/9_Customer_support/SW/
To Next Page
Loading...
Need help?
General