27
LC-32LE63x
LC-40LE63x
LC-46LE63x
Figure 4-7 Main Power Supply
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When defective, replace the whole unit.
4.3.5 Small Signal Board (SSB)
Refer to Figure 4-8
for details.
Figure 4-8 SSB
1. Unplug all connectors [1].
2. Remove the fixation screws [2].
3. Take the board out.
When remounting, ensure that the side shielding [3] is
positioned correctly.
Figure 4-6 Mains switch
The mains switch is mounted on a plastic subframe and can be
removed without removing the subframe.
1. Use a screwdriver and push the switch out of its casing [1].
2. Unplug the connectors [2].
When defective, replace the whole unit.
4.3.4 Main Power Supply
Refer to Figure 4-7
for details.
It is advised to lay the set with front facing down before
executing this operation.
1. Remove all screws from the rear cover.
2. Use a round rod (diameter 2 mm) and insert it in one of the
holes [1].
3. Push the catch located inside the rear cover away by
inserting the rod [2] through the hole and lifting the rear
cover at the same time.
4. Repeat the same procedure on the other hole.
4.3.2 Speakers
Tweeters
Each tweeter unit is mounted with one screw.
When defective, replace the whole unit.
Subwoofer
The central subwoofer is located in the centre of the set and is
secured by two bosses.
When defective, replace the whole unit.
4.3.3 Mains Switch
Refer to Figure 4-6
for details.
Figure 4-5 Bottom catches 40” and 46” sets -2-
19100_049_110216.ep s
110315
2
19100_047_110216.eps
110315
1
Mechanical Instructions (continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
