8
Attaching the stand unit – 70/60LE960X
• Before attaching (or detaching) the stand, unplug the AC
cord.
• Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
• Be sure that two or more persons attach the stand.
CAUTION
• Attach the stand in the correct direction.
•
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
•
After attaching the stand to the TV, do not hold the stand
when you put up, set up, move or lay down the TV.
•
Do not remove the stand from the TV unless using a wall
mount bracket to mount it.
1 Confirm that there are 14 screws (twelve M5
screws and two M4 screws) supplied with the
stand unit.
2 Attach the supporting post to the stand base.
1
Insert the claws of the supporting post into the stand
base.
2
Secure the post and the base using the M5 screws
(length: 60"/70" (14 mm)) and a screwdriver.
M5 screws
NOTE
• Tighten the screws to the holes of the mark “B”.
3 Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the TV.
Improper installation may result in tilting of the TV set.
•
Instead of using a soft cushion, the cardboard box
that the TV is packed in can be assembled and used
as a work table (refer to the instructions on the box to
assemble the work table).
Soft cushion
4 Insert and tighten the M5 screws (length: 14 mm)
into the holes on the rear of the TV.
M5 screws
5 Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten the M4 screws (length: 8 mm) into
the holes of the stand cover.
• Tighten the screws by pressing the bottom of the
stand base to the TV side.
M4 screws
Preparation
LC80LE960X_EN_book.indb 8LC80LE960X_EN_book.indb 8 4/4/2014 1:08:00 PM4/4/2014 1:08:00 PM
To Next Page
Loading...
Need help?
General