EasyManuals Logo
Home>Sharp>TV>LC-60LE960X

Sharp LC-60LE960X User Manual

Sharp LC-60LE960X
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
Attaching the stand unit
80LE960X
Before attaching (or detaching) the stand, unplug the AC cord.
Before performing work, spread cushioning over the surface
on which you will be laying the TV. This will prevent it from
being damaged.
Be sure that two or more persons attach the stand.
CAUTION
Attach the stand in the correct direction.
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
Do not remove the stand from the TV unless using a wall
mount bracket to mount it.
1 Confirm that there are 14 screws (eight M6
screws, four M5 screws and two M4 screws)
supplied with the stand unit.
2 Attach the supporting post to the stand base.
1
Insert the claws of the supporting post into the stand base.
2
Secure the post and the base using the M6 screws (length:
20 mm) and a screwdriver.
M6 screws
NOTE
Tighten the screws to the holes of the mark “B”.
3 Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
Make sure that the stand is firmly inserted into the TV.
Improper installation may result in tilting of the TV set.
Instead of using a soft cushion, the cardboard box
that the TV is packed in can be assembled and used
as a work table (refer to the instructions on the box to
assemble the work table).
Soft cushion
4 Insert and tighten the M5 screws (length: 14 mm)
into the holes on the rear of the TV.
M5 screws
5 Attaching the stand cover.
1
Insert the stand cover.
2
Insert and tighten the M4 screws (length: 8 mm) into
the holes of the stand cover.
Tighten the screws by pressing the bottom of the
stand base to the TV side.
M4 screws
NOTE
To detach the stand unit, perform the steps in reverse order.
A screwdriver is not supplied with this product.
In the installation procedure, be careful not to catch your
fingers between the TV set and the floor.
Preparation
LC80LE960X_EN_book.indb 9LC80LE960X_EN_book.indb 9 4/4/2014 1:08:01 PM4/4/2014 1:08:01 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sharp LC-60LE960X and is the answer not in the manual?

Sharp LC-60LE960X Specifications

General IconGeneral
BrandSharp
ModelLC-60LE960X
CategoryTV
LanguageEnglish

Related product manuals