Sharp R-8680(B) User Manual

To Use the STOP/CLEAR Pad
1. Erase if you make a mistake during programming.
2. Cancel minute timer.
3. Stop the oven temporarily during cooking.
To Cancel a Programme During Cooking
If you are in the process of cooking and wish to stop the oven and cancel the entire cooking programme,
follow either of the steps below:
1. Open the oven door. 2. Close the door. 3. Touch the (STOP/CLEAR) pad.
or
1. Touch the (STOP/CLEAR) pad twice.
MICROWAVE COOKING
There are five preset power levels.
Time Cooking
Approximate percentage of microwave power
for each power level.
4; FULL POWER (HIGH) (Touch the [qf] =<] (MICROWAVE) pad once.) 100% (650W)
4 ROAST (M. HIGH) (Touch the (qi) =<] (MICROWAVE) pad twice.) 70% (455W)
tts SIMMER (MEDIUM) (Touch the (af) =<] (MICROWAVE) pad 3 times.) 50% (325W)
vis DEFROST (M. LOW) (Touch the [df] =<] (MICROWAVE) pad 4 times.) 30% (195W)
<3 WARM (LOW) (Touch the [df] =<] (MICROWAVE) pad 5 times.) 10% ( 65W)
Many foods are cooked at FULL POWER (100%) for best results. The — [ff] (MICROWAVE) pad al-
lows you to select the rate of microwave cooking, but the oven will automatically operate at 4, (FULL
POWER) if the (ip) (MICROWAVE) pad is not touched.
Your oven can be programmed for up to 4 automatic cooking sequences, switching from one variable power
setting to another automatically.
Suppose you want to heat soup for 2 minutes 30 seconds at ry (SIMMER).
1. Enter desired cooking time. (2'30'’) cs Refer to the attached
2. Touch the [tp] (MICROWAVE) pad 3 times. “‘Auto-Touch Sheet”’ E.
3. Touch (MINUTE PLUS/START) pad.
To program a second sequence, for example 1 minute 30 seconds at ty (FULL POWER);
3. After Step 2, enter desired time for second cooking sequence. (1'30’')
4. Touch (MINUTE PLUS/START) pad.
The timer will count down the first sequence and when it reaches zero, the second sequence wil appear
on display and begin to count down. When the timer reaches zero, all indicators will go out and an audible
signal will sound. The time of day will appear on the display.
NOTE: 1. When the door is opened during the cooking process, the cooking time in the readout automati-
cally stops. The cooking time starts to count down again when the door is closedand the
(MINUTE PLUS/START) pad is touched.
2. If the (i) (MICROWAVE) pad is touched after reaching the lowest readout (LOQVV), the
display will return to the starting point (HIGH).
3. If i (FULL POWER) is selected as the final sequence, it is not necessary to bias ch the
(ai) (MICROWAVE) pad.
lf 4 (FULL POWER) is not the final sequence, the [Ui] (MICROWAVE) pad must be
touched.
4. The turntable rotates both clockwise and counterclockwise depending on the position («f motor
when starting the cook cycle.

Sharp R-8680(B) Specifications

Power

AC line voltage	220V, 50Hz
microwave power required	1.3 kW
dual power required	2.8 kW
convection power required	1.6 kW
grill power required	2.6 kW

Output Power

microwave output power	650 W
convection heating element output power	1500 W
grill heating element output power	1000 W

Frequency

microwave frequency	2450 MHz

Capacity

oven capacity	36 litres (1.3 cu.ft.)
turntable tray size	365mm

Weight and Dimensions

outside dimensions	555mm(W) x 380mm(H) x 516mm(D)
cavity dimensions	375mm(W) x 254mm(H) x 385mm(D)
weight	30 kg