Side-Power SE Series User Manual

5
2687
12 2020
-
SE80 & SE100 & SE120 & SE130 & SE150
MC_0124
Thruster Measurements
EN
Measurement
code
Measurement description
mm inch mm inch mm inch mm inch mm inch mm inch mm inch
ID Internal tunnel diameter 185 7,28 185 7,28 185 7,28 185 7,28 215 8,46 250 9,84 250 9,84
H Motor Height 352 13,86 344 13,54 393 15,47 393 15,47 394 15,51 398 15,67 398 15,67
W Width 252 9,92 261 10,28 292 11,50 272 10,71 266 10,47 296 11,65 277 10,91
L Length 206 8,11 206 8,11 240 9,45 240 9,45 243 9,57 250 9,84 249 9,80
WD Water Depth 185 7,28 185 7,28 185 7,28 185 7,28 215 8,46 250 9,84 250 9,84
TL Minimum tunnel length 179 7,05 179 7,05 179 7,05 179 7,05 233 9,17 253 9,96 253 9,96
TL (recommended) Recommended tunnel length 216 8,50 216 8,50 216 8,50 216 8,50 276 10,87 303 11,93 303 11,93
T (min) Minimum tunnel wall thickness 6 0,24 6 0,24 6 0,24 6 0,24 7 0,28 7 0,28 7 0,28
T (max) Maximum tunnel wall thickness 8 0,31 8 0,31 8 0,31 8 0,31 9 0,35 9 0,35 9 0,35
Measurement
code
Measurement description
mm inch
ID Internal tunnel diameter 215 8,46
H Motor Height 412 16,22
W Width 292 11,50
L Length 245 9,65
WD Water Depth 215 8,46
TL Minimum tunnel length 233 9,17
TL (recommended) Recommended tunnel length 276 10,87
T (min) Minimum tunnel wall thickness 7 0,28
T (max) Maximum tunnel wall thickness 9 0,35
*80
12v
*150
24v
*100
12v
*120
24v
*80
24v
*100
24v
*130
12v
*130
24v
*Valid for SE & SEP
MC_0138
Thruster Specifi cations
EN
description * 80 * 100 * 120 * 130 * 150
Available DC System (v) 12v & 24v 12v & 24v 24v 12v & 24v 24v
Thrust 12v or 24v (kg * lbs) 96 kg * 212 lbs 116 kg * 256 lbs 139 kg * 306 lbs 160 kg * 352 lbs 182 kg * 400 lbs
Thrust 10.5v or 21v (kg * lbs) 80 kg * 176 lbs 100 kg * 220 lbs 120 kg * 264 lbs 130 kg * 284 lbs 150 kg * 330 lbs
Typical Boat Size (m * ft) 10m - 15m * 35ft - 48ft 12m - 17m * 35ft - 15ft 13m - 18m * 42ft - 60ft 13m - 19m * 42ft - 62ft 14m - 20m * 44ft - 64ft
Propulsion System Twin Twin Twin Twin Twin
Power (kw * Hp) 4.4kw * 6hp 6.3kw * 8.4hp 6.4kw * 8.55hp 6.5kw * 8.7hp 8.8kw * 11.8hp
Weight (kg * lbs) 20kg * 44lbs 31kg * 68lbs 34kg * 74lbs 37kg * 77lbs 38kg * 79lbs
Minimum Battery Capacity (CCA) 12v * 24v * 48v 550 * 300 750 * 400 400 750 * 400 560
*Valid for SE / SE IP & SEP / SEP IP
MG_0075
TL
WD
H
WL
ID
T
Tunnel centre line
Twin Propeller
The gear leg/ propeller(s) must
never extend out of the tunnel
Propeller position will vary
with each thruster model
MC_0052
Technical Specifi cations
EN
Motor: Custom made reversible DC-motor.
Gearhouse: Seawater resistant bronze. Ballbearing at propeller shaft and a combination of ball bearing and slide bearing at driveshaft.
(Pre- lled and sealed for life)
Motor bracket: Seawater resistant aluminium, galvanically insulated from the motor..
Tunnel: Cross spun with rowing G.R.P tunnel
Steel & aluminium tunnels available at request.
Propeller: 5-blade skewback “Q-prop” propeller,  breglass reinforced composite.
Batteries: Minimum recommended battery capacity (cold crank capacity by DIN/SAE standard)
Contact a battery supplier for more information.
Max. use: 2 - 3 min. duty cycle at 20°
Safety features: - Electronic time-lapse device protects against sudden change of drive direction.
- The electric thermal cut-off switch in electromotor protects against overheating (auto-reset when electro motor cools down).
- Flexible coupling between electro-motor and driveshaft protects electromotor and gear system if propeller jams.
- Original Sidepower panels shut off automatically 6 minutes after last use.
- Original Sidepower panels use child-safe double ON buttons.
- An integrated microprocessor monitors solenoids, reduce wear and risk of solenoid lock-in.
- Auto-stop of the thruster occurs when an undesirable solenoid lock-in occurs or when continuous operation cut-off timer exceeds
3 minutes.

Side-Power SE Series Specifications

General

Brand	Side-Power
Model	SE Series
Category	Outboard Motor
Language	English