© Siemens AG 2003, I:\Mobil\R65\A65_Leopard_abgel._von MC60_Maguro\am\fug\A65_Startup.fm
17Getting started
VAR Language: American; VAR issue date: 21-Januar-2004
left page (17) of CF62 Leopard us-en, A31008-H6050-A40-1-4A19 (24.02.2004, 16:32)
Charge battery
The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a mains
power socket and charge for at least
two hours.
Display when charging is in progress
h During charging.
If Dynamic light is activated for
Charging (page 75) the middle two
LEDs flash slowly to show that charg-
ing is in progress. When the battery
is fully charged, these LEDs switch
off.
Charging time
A flat empty battery will be fully
charged after about 2 hours. Charg-
ing is only possible within a tempera-
ture range of +5 °C to +40 °C. If the
temperature rises/falls 5 °C
above/below this, the charge symbol
flashes a warning. The mains voltage
specified on the power supply unit
must not be exceeded (Operating
time, page 109).
Charge icon not visible
If the battery has been fully dis-
charged, the charge icon is not
immediately visible when the power
supply unit is plugged in. It will
appear after up to two hours. In this
case the battery will be fully charged
after 3-4 hours.
Only use the power supply unit provided!
Display while in service
Charge level display during opera-
tion (empty-full):
adg
A beep sounds when the battery is
nearly discharged. The charge level
of the battery is only displayed cor-
rectly after an uninterrupted charg-
ing/discharging cycle. You should
therefore not remove the battery unnec-
essarily and where possible not termi-
nate the charging process prematurely.
Additional information
The power supply unit heats up when used
for long periods. This is normal and not
dangerous.
If the battery is removed for longer than
30 seconds, the clock will be reset.
To Next Page
Loading...
Need help?
General
