Migration from MC35 to MC35i
PRELIMINARY
Migration from MC35 to MC35i
28 of 30 12.03.03
5.3 List of new AT-Commands
New commands - supported exclusively by MC35i.
5.3.1 GPRS AT commands
Table 17: New GPRS AT commands
# AT Command
144 AT+CGPADDR Show PDP address
147 AT+CGREG GPRS network registration status
5.3.2 Siemens defined AT commands for enhanced functions
Table 18: New Siemens defined AT commands
# AT Command
161 AT^SAIC Audio Interface Configuration
169 AT^SGACT Query all PDP context activation
173 AT^SLMS List Memory Storage
177 AT^SMONC Cell Monitoring
178 AT^SMONG GPRS Monitor
191 AT^SPBD Delete the given Phonebook
202 AT^SSMSS Set Short Message Storage Sequence
5.4 List of unsupported AT-Commands
MC35i supports the entire MC35 AT command set.
5.5 List of AT-Commands for V.25ter compatibility
These commands return "OK" but have no functionality in both MC35 and MC35i.
Table 19: V.25ter compatibility commands
# AT Command
1 ATL Set monitor speaker loudness
2 ATM Set monitor speaker mode
3 ATP Select pulse dialing
4 ATS1 READ-ONLY, INTERNAL USAGE
5 ATS2 Escape code sequence
6 ATS6 Set pause before blind dialing
7 ATS8 Set number of seconds to wait for comma dial modifier
8 ATS9 READ-ONLY, INTERNAL USAGE
9 ATS11-ATS17 READ-ONLY, INTERNAL USAGE
10 ATS19-ATS29 READ-ONLY, INTERNAL USAGE
11 ATT Select tone dialing
To Next Page
Loading...
Need help?
General
