RUGGEDCOM RX1500
Installation Guide
Chapter 3
Communication Ports
19
Communication Ports
The RX1500 can be equipped with various types of communication ports to enhance its abilities and
performance. Each set of communication ports is part of a field replaceable module that makes switching ports
fast and easy.
Use the ROX II software to determine which ports are equipped on the device. For more information, refer to the
ROX II User Guide for the RX1500.
Modules can be installed in any one of the available slots in the RX1500 chassis.
NOTE
Only one T1/E1 module is allowed.
Figure 14: Available Chassis Slots
1. Slot 1 2. Slot 2 3. Slot 3 4. Slot 4
The following sections describe the available ports in more detail:
• Section 3.1, “Copper Ethernet Ports”
• Section 3.2, “Fiber Optic Ethernet Ports”
• Section 3.3, “SFP Optic Ethernet Ports”
• Section 3.4, “WAN Modules”
• Section 3.5, “Serial Ports”
• Section 3.6, “Cellular Modem Modules”
• Section 3.7, “DDS (Digital Data Services) Modules”
• Section 3.8, “RUGGEDCOM APE Module”
• Section 3.9, “Installing/Removing Modules”
• Section 3.10, “Connecting Multiple RS485 Devices”
To Next Page
Loading...
Need help?
General