RUGGEDCOM RX1500
Installation Guide
Chapter 3
Communication Ports
Installing SIM Cards for GSM, EDGE and HSPA+ Cellular
Modems 31
WARNING!
Electromagnetic radiation hazard – risk of serious injury. Do not exceed the maximum antenna gain.
Aside from causing cellular interference for other devices that use the same band, adverse health
effects for individuals in the area may occur.
Frequency Range
Band
Tx (MHz) VSWR Rx (MHz) VSWR
RX Diversity
Support
Maximum
Allowable
Gain (dBi)
f
Band I
WCDMA 2100
1920-1980 < 2.5:1 2110-2170 < 3.5:1
ü
4
Band II
WCDMA 1900
1850-1910 < 2.5:1 1930-1990 < 2.5:1
ü
4
Band VIII
WCDMA 900
880-915 < 2.5:1 925-960 < 3.5:1
ü
5
Band V
WCDMA 850
824-849 < 2.5:1 869-894 < 3.5:1
ü
5
Band VI
WCDMA 800
830-840 < 2.5:1 875-885 < 3.5:1
ü
5
GSM 850 824-849 < 2.5:1 869-894 < 3.5:1
û
5
EGSM 900 880-915 < 2.5:1 925-960 < 3.5:1
û
5
GSM 1800 1710-1785 < 2.5:1 1805-1880 < 3.5:1
û
4
GSM 1900 1850-1910 < 2.5:1 1930-1990 < 2.5:1
û
4
f
Gain limits are reported on certification grants, for consideration against Radio Frequency (RF) exposure and Effective Radiated Power (ERP)/Effective Isotropic
Radiated Power (EIRP) limits.
Section 3.6.4
Installing SIM Cards for GSM, EDGE and HSPA+ Cellular
Modems
To install a SIM card in a GSM, EDGE or HSPA+ cellular modem, do the following:
CAUTION!
Static electricity hazard – risk of damage to equipment. Make sure to take appropriate anti-static
precautions before opening the cellular modem module.
NOTE
The RUGGEDCOM RX1500 only supports mini-SIM cards (2FF size format.
1. Remove the module from the chassis.
2. On the smooth side of the module, remove the four screws and separate the back of the module from the
module chassis.
To Next Page
Loading...
Need help?
General