Siemens RUGGEDCOM RX1500 User Manual

RUGGEDCOM RX1500
Installation Guide
Chapter 4
Technical Specifications
Fiber Optic Ethernet Port Specifications 41
f
Auto-crossover and auto-polarity.
g
RMS 1 minute.
Section 4.5
Fiber Optic Ethernet Port Specifications
The following sections detail fiber optic specifications for ports that can be equipped on the RX1500. The user
determines the type of optics at the time of ordering, and can determine the ports installed on a particular unit by
reading the factory data file via the ROX II user interface. The specifications are organized by order code. Module
order codes are contained within each unit when it is assembled and configured at the factory. For information
about obtaining factory configuration data, refer to the ROX II User Guide for the RX1500.
• Section 4.5.1, “10Base-FL/100Base-SX Ethernet Optical Specifications”
• Section 4.5.2, “Fast Ethernet (100 Mbps) Optical Specifications”
• Section 4.5.3, “Gigabit Ethernet (1 Gbps) Optical Specifications”
Section 4.5.1
10Base-FL/100Base-SX Ethernet Optical Specifications
Mode
Connector
Type
Cable
Type (µm)
Tx λ (typ.)
(nm)
Tx min
(dBm)
Tx max
(dBm)
Rx
Sensitivity
(dBm)
Rx
Saturation
(dBm)
Distance
(typ.) (km)
Power
Budget
(dB)
62.5/125 -16 -9 18
MM ST
50/125
820
-19.8 -12.8
-34 -11.2 2
14.2
Section 4.5.2
Fast Ethernet (100 Mbps) Optical Specifications
Fixed Fast Ethernet Transceivers
Mode
Connector
Type
Cable
Type (μm)
Tx λ (typ.)
(nm)
Tx min.
(dBm)
Tx max.
(dBm)
Rx
Sensitivity
(dBm)
Rx
Saturation
(dBm)
Distance
(typ.) (km)
Power
Budget
(dB)
62.5/125 -19 12
MM ST
50/125
1300
-22.5
-14 -31 -14 2
8.5
62.5/125 -19 12
MM SC
50/125
1300
-22.5
-14 -31 -14 2
8.5
62.5/125 -19 12
MM MTRJ
50/125
1300
-22.5
-14 -31 -14 2
8.5
62.5/125 -19 12
MM MTRJ
50/125
1300
-22.5
-14 -31 -14 2
8.5

Siemens RUGGEDCOM RX1500 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RX1500
Category	Switch
Language	English