SED2 AOP Operating Instructions
14 Siemens Building Technologies
5. Press to confirm the new parameter value.
The AOP returns to the parameter screen so you can select another parameter, if desired.
Press
to return to the r0000 display.
Press
again to return to the previous menu.
Press
for several seconds to return to the status screen (normal operating mode). The
parameter value that has been changed is retained within the AOP’s internal memory, but not
sent to the SED2. Should power to the SED2 or AOP be interrupted, all changes are lost.
TIP: How to quickly change parameter values?
To quickly change a parameter value, use the following procedure to change the single digits of
the display:
1. Press
and the right-hand digit blinks.
2. Press
or to change the value of this digit.
3. Press
again and the next digit blinks.
4. Perform Steps 2 and 3 until the desired value displays.
5. Press
to exit the parameter value
NOTES:
1. Simultaneously press
and , at any time, to return to the main menu.
2. Simultaneously press
and , at any time, to display the parameter help screens.
Editing Indexed Parameters
Use the following procedure to view and edit parameters with indexes.
1. Make certain you are in the expert access level (P0003=3).
2. From the main menu, use
and to scroll through the list of options and to highlight the
Parameters item.
Press
to confirm the selection.
The AOP displays a parameter screen so you can select the desired parameter group or
access level.
3. Use
and to scroll through the groups/access levels and to highlight the desired
parameter group. Press
to confirm the selection?
When you select a parameter group, the AOP displays the first parameter in ascending
numerical order.
4. Use
and to scroll through the list of parameters and to highlight the desired parameter.
Press
to confirm the parameter selection.
5. Press
again to access the parameter index. Use and to scroll through the indexes
and to highlight the desired index.
To Next Page
Loading...
Need help?
General