Server Setup
24
Bus scan
Under this menu item all bus users connected are located automatically, and the corresponding results
are displayed. Click “Start Scan” to initiate the “Bus scan”.
After the message “Scanning done” appears, the ChemWeb Server reinitializes all aspects of the
traced devices. This may take up to 1 minute.
This window also states the software version and the software date of the ChemWeb Server below the
scan results.
ISP configuration
Under this menu item, the ChemWeb Server is supplied with the data from your provider for access to
Internet. Type the data you received from your provider in the corresponding boxes and confirm the
entry by clicking “Send”.
Parameter
This entry box contains the dial data for seizing an exchange line in the case of telephone systems
(0, etc., refer to the operating instructions of the telephone system). Generally, a ring back tone is
not waited for!
To Next Page
Loading...
Need help?
General