Preface
CP 1542SP-1, CP 1542SP-1 IRC, CP 1543SP-1
4 Operating Instructions, 01/2017, C79000-G8976-C426-03
Directly below, you will find the firmware version of the CP as it shipped.
The MAV address is printed on the front at the bottom left, above the connectors for the
power supply.
Product names, terms and abbreviations/acronyms
Below you will find terms and abbreviations/acronyms used often in this manual.
●
When the property being described is valid in the current context for all three CP types or
if the CP type being used is clear from the context, the abbreviation "CP" will be used
instead of the three following product designations
– CP 1542SP-1
– CP 1542SP-1 IRC
– CP 1543SP-1
If information applies only to a certain product variant. the full module name is specified.
●
Control center software "TeleControl Server Basic"
●
PC with installed software "TeleControl Server Basic"
This manual describes the properties of this module and supports you when installing and
commissioning it.
The required configuration steps are described as an overview and there are explanations of
the relationship between firmware functions and configuration.
You will also find information about the diagnostics options of the device.
To install, commission and operate the CP, you require experience in the following areas:
● Automation engineering
● Setting up the SIMATIC ET 200SP
● SIMATIC STEP 7 Professional
Editorial revision (MSIP approval)
Release 11/2016
To Next Page
Loading...
Need help?
General
