Approvals
11
The SIMATIC NET products described in these Operating Instructions have the approvals listed
below.
Note
Issued approvals on the type plate of the device
The specied approvals apply only when the corresponding mark is printed on the product. You
can check which of the following approvals have been granted for your product by the markings
on the type plate.
Current approvals on the Internet
You will nd the current approvals for the product on the Internet pages of Siemens Industry
Online Support (https://support.industry.siemens.com/cs/ww/en/ps/15273/cert).
Notes for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive or the Supply of
Machinery (Safety) Regulations (UK).
There is therefore no declaration of conformity relating to the EC Machinery Directive
2006/42/EEC or the Supply of Machinery (Safety) Regulations 2008 (UK) for this product.
If the product is part of the equipment of a machine, it must be included in the procedure for
obtaining the EU/UK conformity assessment by the manufacturer of the machine.
Machinery directive
The product is a component in compliance with the EC Machinery Directive 2006/42/EEC and the
Supply of Machinery (Safety) Regulations 2008 (UK).
According to the Machinery Directive respectively the Supply of Machinery (Safety)
Regulations (UK), we are obliged to point out that the product described is intended solely
for installation in a machine.
Before the nal product can be put into operation, it must be tested to ensure that it
conforms with the Machinery Directive 2006/42/EEC and the Supply of Machinery (Safety)
Regulations 2008 (UK).
EC declaration of conformity
The SIMATIC NET products described in these operating instructions meet the requirements
and safety objectives of the following EU directives and comply with the harmonized
SCALANCE XR-300
Operating Instructions, 03/2023, C79000-G8976-C586-02 105
To Next Page
Loading...
Need help?
General