Migration Guide Comfort Panels
Getting Started, 03/2011, A5E03478626-01
43
Commissioning the HMI device
4
4.1 Overview
To transfer the migrated project from the configuration PC to the Comfort HMI device,
connect the Comfort HMI device with one of the following interfaces on the configuration PC:
● Ethernet
● USB
● PROFIBUS/MPI
After successful transfer, you can insert the system memory card in the Comfort HMI device
and activate automatic backup as part of the service concept.
In the event of a fault, it is usually sufficient to restart the device or update the operating
system. Resetting to factory settings ("bootstrapping") is only necessary in case of serious
errors, for example, in case of a corrupt file system.
4.2 Transferring a project
NOTICE
Note the information regarding connection of an HMI device to a configuration PC in the
operating instructions of the Comfort HMI device.
The project transfer is shown based on a USB connection.
Requirements
A project with configured Comfort HMI device is open in WinCC.
To Next Page
Loading...
Need help?
General
