Siemens SINUMERIK 802C base line User Manual

SINUMERIK 802C base line Control System
1-2 SINUMERIK 802C base line
Start-Up
Software components
The SINUMERIK 802C base line comprises the following software components,
which can be ordered:
z
System software on the permanent flash memory of the CNC
 Boot software
loads the remaining system software from the permanent memory
into the user memory (DRAM) and starts the system.
 MMC software (Man Machine Communication),
implements all operating functions
 NCK software (NC Kernel)
implements all NC functions. This software controls an NC channel
with a maximum of 3 movement axes and a spindle.
 PLC software (Programmable Logic Control)
executes the integrated PLC user program cyclically.
 Integrated PLC user program
intended to adjust the SINUMERIK 802C base line to the machine
functions (see also Description of Functions “Integrated User
Program for SINUMERIK 802C base line”).
z
Toolbox
 WinPCIN transfer program for a PC/PG (programming device) to
transfer user data and programs
 Text manager
 Cycle kit for loading into the control system using WinPCIN
 User program library
 Technological machine data files
 Programming tool
z
Update diskettes
 Update program with operator prompting system
 802C base line system software, packed, for loading and programming
the SINUMERIK 802C base line via an update program.
User data
User data are:
z
Machine data
z
Setting data
z
Tool data
z
R parameters
z
Zero offsets
z
Compensation data
z
Part programs
z
Standard cycles
Data saving
Modified user data are saved for at least 50 h after power off or power failure.
After then, they might get lost.
Warning
To avoid data loss, the operator must carry out data saving (see Section 4.1.4).
!

Siemens SINUMERIK 802C base line Specifications

General

Brand	Siemens
Model	SINUMERIK 802C base line
Category	Controller
Language	English