Start-Up
4-46
SINUMERIK 802C base line
Start-Up
4.7.4 Completing the Start-Up
After start-up of the control system by the machine manufacturer, the following
should be observed prior to delivery to the final customer:
1. Change the default password for access level 2 from ”EVENING” to your
own password.
If the machine manufacturer uses the password ”EVENING” for access
level 2 during the start-up work, the password must be changed.
Press the softkey Change passw.
Enter the new password and press OK to confirm.
Note the password in the Manufacturer Documentation.
2. Reset the access level.
To save the data which have been set during the start-up, an internal data
saving is required. To this aim, set access level 7 (final customer);
otherwise, access level 2 will also be saved.
Press the softkey Delete passw.
The access level will be reset.
3. Carry out internal data saving.
Press the softkey Save data.
4.7.5 Cycle start-up
Sequence of operations
When loading cycles into the control system, adhere to the following sequence
of operations:
1. Save tool offset data and zero offsets either on the FLASH or on the PG
(programming device).
These data can be selected in the Services menu by pressing the Data
outp./data...softkey.
2. Load all files of the selected technology path from the toolbox diskette
into the control system via the V24 interface.
3. Carry out POWER ON.
4. Reload the recovered data.
To Next Page
Loading...
Need help?
General
